DiamondCore Hole Drills (Sold Individually, 3mm - 100mm)
DiamondCore® Hole Drills can be used to make holes in bisque or high-fired ceramic, tile, or glass. These hole drills allow you to create a hole after the final high-temp firing without having to calculate shrinkage.
*Select a specific hole drill bit size above to view the corresponding product image
DESCRIPTION:
- Diamond hole drills for ceramics
- Select sizes: 3 mm through 100 mm diameters
- Individually priced
USES:
- Create holes in bisque or high-fired ceramic, tile, or glass
- Drill holes for plugs, hanging pieces, a drain hole for a plant
- Make holes for fountains, sink basins, fittings, fixtures, etc.
BENEFITS:
- Create a hole after the final high temp firing
- No need to calculate shrinkage to get the desired size
- Long lifespan if used properly with water
- Dust is controlled with water use
- Shaft size for normal household 3/8" cordless drill
- As the tool wears, a new layer of diamonds is exposed
- Much longer lasting than diamond edge hole drills
CAUTIONS:
- Use all safety precautions
- Always use safety goggles
- Always check to remove the core after each drilling
- Make certain that debris does not get into moist clay
- Always use water to maximize tool life and control dust
- Use a normal cordless drill and avoid getting water in the drill
- Do not attempt to force or pry with this tool
- Keep out of the reach of children
Note: Keep the diamond section of the drill bathed in the water while drilling. Start at a slight angle to get started, then tilt upright and use light pressure and a gentle rotation motion. “Let the diamonds do the work.” For longevity, use water, high speed, and gentle pressure. Overheating the tool will decrease tool lifespan and alter the tool shape.
Recently viewed